摘要 : The all-inorganic perovskite material (CsPbBr_3) is a promising light-emitting material due to its narrow color spectrum, wet solution processability, and cost-effectiveness. Despite such advantages, pinholes, poor surface coverag... 展开 The all-inorganic perovskite material (CsPbBr_3) is a promising light-emitting material due to its narrow color spectrum, wet solution processability, and cost-effectiveness. Despite such advantages, pinholes, poor surface coverage, and stability issues limit widespread applications of perovskite light-emitting devices (PeLEDs) in solid-state lighting applications. The performance of PeLEDs depends strongly on the morphological characteristics of the perovskite layer, with low surface coverage and surface roughness observed to lead to higher current leakage and lower current efficiency. We find that perovskite thin films blended with polymers to form composite layers effectively enhance the thin film's surface coverage and uniformity, improving performance. We report CsPbBr_3 PeLEDs with dual polymer additives, with a 12.1% reduction in the turn-on voltage (V_(on)), a 97.21% reduction in leakage current density, a 200%+ enhancement in maximum brightness, and a 700% increase in power efficiency compared to a control CsPbBr_3 device. To study the likely source of these enhancements, we have conducted a comparative film analysis of test and control devices using field-emission scanning electron microscopy and atomic force microscopy. A reduced crystal grain size (～204nm to ～101 nm) and a nearly 100% (99.79%) surface coverage (compared to 79.53% found for control devices) suggest that the improved overall morphology and surface coverage likely play a significant role in the improved performance. Further, a reduction in surface roughness (～45%) and the formation of a nearly pinhole-free film are observed to increase yield by 20%. 收起