摘要 : Abstract Potholes are one of the most common road distresses in Kuwait especially after winter season in 2018. Pavement deterioration rate significantly increases as the pavement exposes to moisture. Paving road requires using hig... 展开 Abstract Potholes are one of the most common road distresses in Kuwait especially after winter season in 2018. Pavement deterioration rate significantly increases as the pavement exposes to moisture. Paving road requires using high-quality materials. This paper aims to investigate the feasibility of using recycled asphalt pavement in hot mix asphalt (HMA) design. Questionnaires and a series of laboratory tests were conducted to analyze the effects of pores on the society and test the recycled and the regular mixtures performance to choose the best option regarding it. Marshal test portrayed that the recycled mixture has a high stability and flow. According to the tensile strength ratio test requirements which set a minimum ratio of 75%, it is recommended to reduce the proportion of recycled aggregate. The Hamburg wheel tracker (HWTD) test proved that the recycled asphalt mixture has a low rutting depth for wet and dry samples compared to the general one. On the other hand, the wet recycled mixture requires a reduction by of 20% to satisfy the specifications. The physical properties for both mixtures were compared, and the voids filled with asphalt (VFA) and voids in mineral aggregate (VMA) of the recycled mixture are lower than those in the regular mixture. The recycled mixture reveals a higher efficiency in saving costs and improving mixtures used for potholes maintenance activities. All the results proved that the mixtures consisting of recycled asphalt are most preferred since they are affordable and perform reasonably well compared to mixtures made of regular asphalt. As a future work, smaller percentages of recycled aggregate should be tested to check the robustness and sustainability of the designed recycled asphalt mixture using different tests such as Hamburg wheel tracker test (wet samples) and indirect tensile strength test. Furthermore, more experiments can be run to test other mix parameters and properties such as durability. 收起